Comment by walter-boring for Solved this issue by using iSCSI instead of FC.
That's not much of a 'solution' to the problem. Did you even try the suggestions?
View ArticleAnswer by zetret for I have a block storage configured using Cinder (on...
Solved this issue by using iSCSI instead of FC.
View ArticleAnswer by jgriffith for I have a block storage configured using Cinder (on...
Your missing info in your Fibre Channel configuration for the IBM Storwize driver, or the Storwize FC driver is flat out busted (I suspect it's a config issue). You will likely have better luck working...
View ArticleAnswer by walter-boring for I have a block storage configured using Cinder...
If this is for FibreChannel: 1) You need to make sure you have the kernel driver/module loaded for your FC HBA card. This is typically lpfc for Emulex cards 2) You need to have systool installed. For...
View ArticleAnswer by Guestvn for I have a block storage configured using Cinder (on...
I have same problem,i using FC but i cannot upload image to volume. Can you help me ?
View ArticleAnswer by kishore for I have a block storage configured using Cinder (on...
I am running into similar issue. It seems the if you use the UUID of an existing cinder volume and UUID of an existing instance using (cinder::Attachment), it is able to attach the volume with no...
View ArticleComment by zetret for I have a block storage configured using Cinder (on...
I have edited the question to reflect what you asked. I've also posted new errors in volume log. Please take a look. Thanks.
View ArticleComment by mickt for I have a block storage configured using Cinder (on...
Can you launch an instance using 'Boot from image (creates a new volume)'? Be sure that you have large enough space available for the new volume. I've had issues with cinder whereby volumes will not...
View ArticleComment by mickt for I have a block storage configured using Cinder (on...
Also, subsequent volumes attach fine but volumes created prior to the above step never attach so I just deleted them.
View ArticleVolume-attach fails - ERROR No initiators or wwpns supplied.
I have a block storage configured using Cinder (on Juno). A new volume was created and its state shows as "available". I have a nova instance (a test Cirros instance) configured. I want to attach this...
View Article
